Jump to content

Toolserver:Admin:Service processors

From mediawiki.org

This page was moved from the Toolserver wiki.
Toolserver has been replaced by Toolforge. As such, the instructions here may no longer work, but may still be of historical interest.
Please help by updating examples, links, template links, etc. If a page is still relevant, move it to a normal title and leave a redirect.

Service processors are used to access serial consoles, power-cycle servers and retrieve hardware information.

Sun V20z / V40z (SP)

[edit]
This applies to: zedler
  • Connect with ssh system@machine.mgmt. Password is the root password.
  • Commands:
    • platform console: connect to the serial console (type ^Ec. to exit)
    • platform set power state off -f: turn the machine off
    • platform set power state on -f: turn the machine on
    • platform set power state cycle -f: power-cycle the machine
    • Exit by typing ^D

Sun X4100/X4150/X4250 (ILOM)

[edit]
This applies to: hemlock, rosemary, amaranth, cassini, ptolemy, daphne
  • Connect with ssh root@machine.mgmt. Password is the root password.
  • Commands:
    • start /SP/console: connect to the serial console (type ESC ( to exit)
    • stop /SYS: turn the machine off
    • start /SYS: turn the machine on
    • reset /SYS: power-cycle the machine

Sun X2** (ELOM)

[edit]
This applies to: turnera, damiana
  • Connect with ssh root@machine.mgmt. Password is the root password.
  • Commands:
    • start /SP/AgentInfo/console: connect to the serial console (type ESC ( to exit)
    • reset: power-cycle the Service processor
    • set /SP/SystemInfo/CtrlInfo PowerCtrl=reset : Reboot the system by typing the following command from the SP CLI
    • set /SP/SystemInfo/CtrlInfo PowerCtrl=forceoff: turning the system hard off
    • set /SP/SystemInfo/CtrlInfo PowerCtrl=on : turning the system on again

Dell PowerEdge 1950 (DRAC)

[edit]
This applies to: yarrow, nightshade, willow
  • Connect with ssh root@machine.mgmt. Password is the root password.
  • Commands:
    • connect com2: connect to the serial console (type ^\ to exit)
    • racadm serveraction powerdown: turn the machine off
    • racadm serveraction powerup: turn the machine on
    • racadm serveraction powercycle: power-cycle the machine

If you get "connect: com2 port is currently in use" when trying to use the serial console: reset the SP with "racadm racreset", wait a couple of minutes, and reconnect.

Dell PowerEdge R520 (DRAC)

[edit]
This applies to: sage and yucca.

Same as the 1950, but to connect you just type "connect" (without the port).

Systems on the SCS

[edit]
This applies to:
  • Connect to the SCS: ssh root@scs-oe10-esams.esi. Password is the root password.
  • Then use pmshell -l portXX (see scs-oe10 for XX).
  • This will connect you to the SP, where you can log in and run commands as described above.

Category:Admin:Servers